Model: NL-SNG-3
The problem
Hoses are the weakest link in sanitary and gas piping: braid bulging, liner swelling and fittings pulling apart usually show up only when a hose bursts at a user site. Manual pressurising and visual checks cannot reproduce the 0.8MPa hold, the 6MPa static proof, the 98degC hot-water duty or the 10-second water-hammer impact that the standards call for, and they leave no comparable record.
Capability
Three stations run one to three hoses in parallel, mounted at 90deg or 180deg as the standards require. Static proof pressure is settable from 0 to 6MPa with 0.01MPa control accuracy and no more than 0.02MPa deviation, covering the CJ/T 197-2010 0.8MPa one-minute proof as a baseline and going well beyond it for higher pressure classes. Pulsation pressure runs 0.2-3.5MPa at 0.05-1Hz (3-40 cycles per minute) with a choice of basic square wave or water-hammer wave. Media temperature is room temperature to 98degC (expandable to 0-100degC); the hot-water dynamic cycle, 82-93degC at 0.9MPa with a 3-minute preheat followed by ten impacts at 10-second intervals, is fully programmable and ends with a static hold at the set pressure. A 50L stainless tank with heating and temperature control is topped up automatically. Each station has independent pressure and flow adjustment, a vented plug at one end so air is expelled before pressurising, and a guarded door that must be closed before pressure can build. Configurable software logs pressure, media temperature, cycle count, frequency and waveform, saving data periodically so the whole test can be reviewed later. Over-pressure, over-temperature, burst and leakage stop the test automatically; E-stop and safety guarding allow unattended long runs.
Key specifications
- Application: pressure tightness, pulsation and burst testing of sanitary and gas hoses
- Stations: 3, one to three hoses in parallel
- Static proof pressure: 0-6MPa settable, 0.01MPa control accuracy, deviation <=0.02MPa
- Pulsation pressure: 0.2-3.5MPa settable
- Pulse frequency: 0.05-1Hz (3-40 cycles/min)
- Waveform: basic square wave or water-hammer wave
- Media temperature: room temperature to 98degC (0-100degC optional)
- Dynamic cycle: 82-93degC at 0.9MPa, 3min preheat, ten impacts at 10s intervals
- Mounting: 90deg or 180deg, per standard sample attitude
- Media and tank: tap water, 50L stainless tank with auto top-up
- Data: pressure, temperature, cycles, frequency and waveform logged and reviewable
- Safety: over-pressure / over-temperature / burst stop, door interlock, E-stop
Applications
Hose pressure and fatigue validation at sanitary hose, shower hose and braided hose plants; gas hose proof testing; incoming inspection by sanitary and gas appliance brands; third-party hose pressure, pulsation and burst testing
About the manufacturer
Guangdong Endurance Electronic Equipment Co., Ltd provides non-standard customization, drawing confirmation, factory acceptance, on-site installation and commissioning, operation training and long-term technical service; 12-month warranty and long-term spare parts supply. Tel: 0760-88500902 / 13416787649. Web: en.zsnaili.com.
广告
