Model: NL-QYQ-20
The problem
The traction actuator drives drain and spin, and when it slips or jams in the field it becomes a batch service problem. Manual on-off benches cannot apply a defined load, cannot show travel, and cannot reproduce humid heat or winter cold - so failure curves are guesswork.
Capability
Twenty stations test drum and pulsator washer traction actuators in parallel, each station mapped to its display. A programmable single-phase AC supply covers 0-300V at 1000W with adjustable voltage and frequency, feeding five channels. Gravity loading uses 58.8N and 110N weight sets on a 10s ON / 5s OFF cycle with settable pauses; traction travel 0-15mm is displayed in real time and an in-position sensor stops the station immediately on slip, with audible-visual alarm. Counting reaches 300000 cycles automatic (settable from 50000), with run and dwell times programmable. An environmental chamber holds -5 to +50degC at 85-90%RH to reproduce humid-heat and cold conditions. Electric-parameter meters log voltage, current and power per group, with the industrial PC storing all results; manual and automatic modes, and the true pull-hold-release sequence against drain valve and clutch pawl timing is replayed every cycle.
Key specifications
- Application: durability testing of drum/pulsator washer traction actuators
- Stations: 20, station-to-display correspondence
- Supply: programmable AC 0-300V / 1000W, adjustable voltage and frequency
- Counting: automatic up to 300000, settable from 50000; run/dwell programmable
- Load: 58.8N and 110N weight sets, adjustable and displayed
- Cycle: 10s ON / 5s OFF, pauses settable
- Travel: 0-15mm real-time display; slip detection stops immediately with alarm
- Chamber: -5 to +50degC, 85-90%RH
- Data: electric-parameter meters + industrial PC logging and storage
- Configuration: 5 sets of supply/control/switching modules, gravity loaders and meters + console + PC
Applications
Life validation at traction actuator and drain executor plants; incoming reliability audit by washer OEMs; third-party component testing; drain clutch assembly R&D verification
About the manufacturer
Guangdong Endurance Electronic Equipment Co., Ltd provides non-standard customization, drawing confirmation, factory acceptance, on-site installation and commissioning, operation training and lifetime technical service; 12-month warranty and lifetime spare parts supply. Tel: 0760-88500902 / 13416787649. Web: en.zsnaili.com.
广告
